Innholdsfortegnelse for August 2025 i Guns & Ammo

THERMAL INERTIA In “Gun Tech” (May 2025), Richard Nance used a barrel supplied by Avient featuring a ceramic material in the middle designed “to quickly transfer heat from the steel bore.” However, he didn’t say where the heat goes. It seems that the only place for the heat to go is into the carbon-fiber layer. Since carbon-fiber has only about half the thermal conductivity of steel [.17 to 27 W/(m x K) versus 45 to 60 W/(m x K)], and considerably lower density — thus reduced thermal mass and reduced weight of the layered barrel — it follows that the steel liner in the layered barrel would get hotter compared to an all-steel barrel of similar profile. The outside of the layered barrel would remain cooler because of the same…

THE IMPETUS FOR THIS COLUMN followed a discussion concerning my review of the Rost Martin RM1S in Guns & Ammo (April 2025). The RM1S includes one flush 12-round magazine and one extended 15 rounder. In that article, I mentioned how the extended magazine provided more control because I could get my entire hand around the grip. The only downside was that the longer mag was tougher to conceal for carry. I preferred shooting the RM1S with the extended magazine in place, but that’s not surprising. Almost without exception, I prefer the feel of the extended magazine, too, not just in my hands, but while shooting. I got into this business from the competition side, so I generally approach new firearms from a that perspective. But how hard is it to…

THERE IS A VAST AMOUNT OF INFORMATION available on smokeless powders, including burn rate charts, reloading manuals, and propellant profiles by experts such as Ken Waters. Just about anything a shooter or reloader might want to know about propellants — relative speed, appropriate cartridge use, performance for uniformity and accuracy — is all well documented. Not so when it comes to primers. About all that is readily available is what size they are and whether a primer is “standard” or “magnum.” Some are marketed as “match” primers, but there is little objective data revealing whether these more expensive primers really achieve better performance versus standard primers. What are the real differences between primer types and brands? How do they perform relative to each other? How should a reloader decide which…

AT GUNS & AMMO, we take pride in our mandate to review any firearm category or topic. However, the once-per-month publication means if anything is missed in an issue, it may need to be covered in the next month’s. Being a general interest publication, though, can mean that some readers only get a taste of their particular interest. A pistolero may skip straight to James Tarr’s latest handgun feature, leaving the other articles unread. For those who want a focused experience, allow me to introduce the Outdoor Sportsman Group’s Special Interest Publications (SIPs) Division. “We’re the opposite of a general firearm magazine such as Guns & Ammo,” said SIP Editor-in-Chief D. Faubion. “By producing a variety of special interest magazines for the Guns & Ammo brand — ‘AR-15,’ Suppressor,' ‘Rimfire,’…

@GUNSANDAMMOMAG STANDING 5-FOOT-4 and a couple of pounds over 110, my earliest memories of Mom — Rhonda Poole — are of a God-serving woman who loved my sister Rachelle and I more than anything. “Dad,” named Roy, was a police officer in Ridgecrest, California, when he rescued us from my biological father’s abusive marriage. Roy married Rhonda on Christmas Eve, 1982. Mom chose to be a homemaker, raising Rachelle and I on a small desert property with nearly 150 chickens, a few rabbits, a duck, and a couple of cats and dogs. She went from being a woman who didn’t know anything about guns to someone who carried them for both defense and the enjoyment of shooting. Several memories of Mom involve her wearing a gun, either a rimfire Colt…

IN 2024, former Guns & Ammo Publisher Doug Hamlin took the reins as CEO and Executive Vice President of the National Rifle Association (NRA). He stepped into the unenviable position of cleaning up the waste left in the wake of Wayne LaPierre and his cronies. I wished Mr. Hamlin well, but given the circumstances, I wasn’t overwhelmed with optimism. A year after his election to the role, I sat down with Hamlin for a one-on-one meeting at the NRA Annual Meeting in Atlanta, Georgia. He looked me in the eye and shot me straight. No question was off the table. After months of quiet observation, backchannel discussions with NRA staff, and finally this sit-down, I am convinced that the organization is on the right path. Serving six years as a…

ELABORATE 1911 Q: I inherited this 1911 .45 ACP from my father in 1990 and was hoping you could give me some information. The only marking on the pistol is the serial number, 144XXX. My father told me it is a Llama, and he acquired it from a friend in the mid- to late-1960s. It originally had white grips, which I believe were plastic. I do not know if the engraving is factory or not, but it was on the piece when he got it. The gun performs flawlessly, and I have personally fired thousands of rounds with this pistol. As a matter of fact, I just used it to qualify for my Maryland wear and carry renewal. I do not use it for concealed carry, but I am so…

PISTOL-MOUNTED LIGHTS ensure you can illuminate your environment whenever your gun is in hand. Well-designed lights such as Streamlight’s TLR-1 HP-X enable reliable activation while supporting a two-hand shooting grip to best manage recoil. The TLR-1 HP-X sports customizable rear activation via paddle switches that operate the light from either side, with either hand. The TLR-1 HP-X is compatible with most pistol rails. The package includes one rail key installed and several others. If the factory-installed key doesn’t fit your pistol rail, select a key that will. A compatibility list is available at streamlight.com. Changing the rail key is simple using the supplied multi-tool. The process is detailed in the product instructions. After ensuring the TLR-1 HP-X is configured to mount to the rail of your pistol, it’s time to…

“LICK-EES” AND “CHEW-EES.” Snacks of this nature are highly coveted during a long day afield. Anyone who has served in the military probably spent considerable time on training exercises where they’d be visited by the colloquially named “gut truck” or “roach coach.” Civilian entrepreneurs would often load these trucks with the worst junk food options one could imagine, selling them to captive soldiers, sailors and Marines on military installations. Seemingly hated by first sergeants everywhere, they were always an immediate distraction. Yet, small-unit leaders knew the value of a morale-boosting treat when the only meal troops could look forward to was prepared by field kitchens or in an MRE. Snacks aren’t just applicable to servicemembers, though. Hunters in a treestand or blind and shooters spending long training days at a…